The water of the last bath (but without foam bath additive) can also be used for cleaning. Add 100ml (approx. 1/8 liter) to 250-350 liters of water Whirlpool System Cleaner (Order No. 70-102) to the tub. Then turn on the pump (blower and two-way mixer if available) for a few minutes so that the cleaning agent is distributed in the pipes and in the tub.

Then turn off and let the detergent-enriched water soak in the tub. It is recommended to leave the water in the tub for a few hours or overnight. Before emptying the tub, run all aggregates again for approx. 1-2 minutes. However, we still recommend a manual post-cleaning. To do this, rinse the tub with the shower hose and then fill it again with cold water. Now switch all units on and off briefly a few times. Open the drain and leave it in this position until the next use of the tub.

In case of normal use, we recommend this cleaning approx. every 4 weeks or as needed. Cleaning of the pipe system is possible only when the tub is full! 

Dosage: 100ml (approx. 1/8 liter) to 250-350 liters of water. 

Surface Cleaning 

The whirlpool system cleaner can also be used undiluted on a cloth, for cleaning the surface. After such a surface cleaning, the tub must be thoroughly rinsed with the shower hose. Leave the drain in the open position until the next use of the tub.